29. December 2009 17:15
While film release liners are great since once you get them started they can be removed very quickly from a roll of tape without the possibility of the liner ripping like a paper release liner may at times do; nonetheless they can sometimes be hard to get started.
The easiest way to remove a release liner is to unwind a section of the tape from the roll and apply that section of tape to the first surface you are bonding to and then let the adhesive set before you try and remove the liner. However if you need to remove the release liner before the adhesive has set on the first surface here are some tips or guidelines to follow:
- Unwind a short length of tape from the roll.
- Bend a small amount (1/8 to 1/4 inch from the corner) of one of the corners back towards the liner side (so the liner is touching liner) - this will cause the film liner to stretch more than the backing on the tape which will typically result in the liner overhanging the tape by a little bit.
- Then try to drag the tape away from the liner with your thumbnail while using another fingernail to squeeze or pinch the liner in place.
- Once you get enough of the liner removed you will have something to hold on to in order to start pulling the release liner away from the tape.
*** if you have trouble removing the liner with your fingernails you can also try a pair of tweezers, razor blade or utility knife to help separate the release liner from the tape