JVCC FTTD2 Foam Tape Table Top Dispenser dispenses foam tapes with a max outside diameter of 14-1/2 inches (370mm) while removing liner onto a spool. Peeled tape is ready to use and cut with scissor blades. Sliding arm allows for measuring preset lengths up to 500mm. Powder coated steel construction. For tape on a 3 inch core. The spool has adjustable breaks.
Dispenser Instructions:
- Fix the core holder extension (top right in photo) my means of the two handwheels enclosed in the package.
- There are a few possible ways to thread the tape through the spools on the dispenser (click on the 'Download Instructions' icon below to see a few possibilities). The best set up of the dispenser is that which permits the complete rewind of the liner on the spool under minimum effort. The knobs of the core holder and the spool can be adjusted to change the torque required.
.
|
|
|
For tape up to 2" wide
* typically takes approximately 2 extra business days to ship | FTTD2 | 1 | SINGLE DISPENSER (1 to 1 dispensers) 1 TO 2 CASES(1, 2 dispensers) 3 TO 4 CASES(3, 4 dispensers) 5+ CASES(5, 6, 7, ... dispensers) | $218.45 $218.45 $214.75 $212.90 | * see individual dispenser price to left $218.45 $214.75 $212.90 |
|---|
** special order sizes are not returnable (and non-cancelable if material has been ordered or cut before the cancellation request was made)
** special order sizes for this item typically ship direct from our supplier so will not ship together with stocked products
hot melt rubber (synthetic)
Offers the widest range of application flexibility available. Exhibits excellent processing performance whether manually or automatically applied. Has superior tensile strength, adhesion properties and holding force which ensures consistent, reliable seals. Hot melt adhesive will bond faster to a surface which is referred to as quick-grab or quick-stick. It typically has higher tack (will feel stickier to the touch), but is also softer. It has lower heat resistance, shear resistance, and sometimes UV resistance than an acrylic adhesive. NOTE: it is called hot melt because the adhesive is applied hot by the manufacturer and then hardens as it cools (you do not need to apply heat to the tape yourself).
natural rubber
Properties are similar to that of hot melt rubber, but natural rubber often holds where other adhesives won't (recycled fibers, dust, cold, heat and heavy loads). It provides good overall adhesion and moisture resistance.
acrylic
Offer excellent performance, especially for applications in temperatures less than 40°F and greater then 120°F. It provides excellent clarity, has high shear strength, is usually more permanent/durable even when exposed to moisture, and it ages well over extended periods in fluorescent and sunlight. Since it remains clear for the life of the application and does not yellow over time it is ideal for applications such as sealing white cartons. While it has good initial adhesion it does take 24-48 hours to cure and to achieve its maximum bond strength (has gradual adhesion buildup). Another difference between hot melt rubber and acrylic adhesive is if you fold tape over making the two adhesive sides touch the acrylic adhesive will remain attached to the carrier (e.g. paper, film) while a hot melt adhesive will stick to itself and pull off of the carrier. It is the best choice for clarity, UV resistance and aging characteristics.
silicone
Is great for extreme temperature applications since silicone adhesive can work in continuous operating temperatures from -100°F to 500°F. They also exhibit good chemical resistance, retain electrical properties, and remove cleanly with little or no residue.
zinc oxide
Zinc oxide based adhesive formula is a skin-friendly adhesive which is commonly used on sports medicine tapes.
1 mil = 1/1000 of an inchExamples: 1/16 inch = 62.5 mils; 1/32 inch = 31.25 mils
