ATG tape dispensers are used to apply ATG tape (adhesive transfer gun tape) on picture framing, product assembly, scrapbooking, and design & packaging prototypes.
- JVCC ATG1 ATG Tape Dispenser
JVCC ATG1 ATG Tape Dispenser is a hand held tape dispenser for ATG tape. The dispenser/applicator will automatically wind up the liner on your ATG tape during use. It will accommodate both 1/2 inch and 3/4 inch rolls of ATG tape (it accepts 1/4 inch ATG tape also although rolls may slide around a bit on the spool since the spool is wider than the tape; however some people find it not to be an issue). All of the ATG tapes we sell will fit in the ATG1 dispenser. The dispenser color will either be blue, red, teal or orange depending on the color of the last lot received in. For a visual guide to loading and using refill rolls in a JVCC ATG1 dispenser please see http://www.findtape.com/inserts/ATG-Loading-Instructions.pdf. USAGE NOTES: Start by putting the roll of tape on the spool in the middle of the gun with the tape running down clockwise (make sure the roll snaps down on to the spool so that if you pull on the tape the roll does not spin freely on the spool unless you are also holding the trigger down). It then runs on top of the roller closest to it and then under the roller in the front of the gun. During usage the adhesive gets applied at the point of the front roller so when you are first loading the gun remove any adhesive off the liner by hand at this point so only the liner then comes back over the roll which is on the main spool in the middle of the gun and then runs under the liner take-up spool (secure the liner in one of the slits in that spool). Then hold the trigger down when applying the tape (it allows the spools to turn). To stop applying let go of the trigger and pull the dispenser away. %ATGMatrix%
- 3M Scotch 700 ATG Adhesive Applicator
3M Scotch 700 ATG Adhesive Applicator allows with the touch of the finger quick, controlled application of strips of ATG pressure-sensitive adhesive tape. Bond lines are thin. No mess or clean-up. The ATG acrylic adhesive flows into surface irregularities to join, mount or laminate. %ATGMatrix%
- 3M Scotch 714 1/4" ATG Adhesive Applicator
3M Scotch 714 1/4" ATG Adhesive Applicator allows with the touch of the finger quick, controlled application of strips of ATG pressure-sensitive adhesive tape. Covered gears minimize applicator jams. Transparent cover shows remaining tape. Holds up to 60 yards of 1/4" ATG tape. Bond lines are thin. No mess or clean-up. The ATG acrylic adhesive flows into surface irregularities to join, mount or laminate. %ATGMatrix%